|First Shift-13 hourly
*2nd shift - pay rate $13.50/hourly
Third- 14 hourly
General Statement of Position Scope:
Operate and start up heated Molding presses to mold and cure company products.
Specific Responsibilities: (See Addendum of ADA Compliance requirements for the essential job functions.)
Spray inner surfaces of molds, mandrel(s) with lubricant, as required.
Assemble and pre-heat components and mandrels prior to inserting into press, when required.
Mold switchgear diaphragm in accordance with SOP’s. Inspect each piece for cosmetic flaws; use light to inspect interior of
work pieces as needed. Remove flash from mold.
Remove molded piece(s) from press completion of cycle, remove mandrel(s) from work piece(s).
Have first piece(s) inspected by Q.C. Check each piece for cosmetics, no-bond, bubbles, etc., use light to inspect interior of work
piece(s), when required.
Remove flash from mold; trim work piece(s).
Maintain quality and production standards.
Run Tandem operation when they are scheduled.
Make minor adjustments on press(es), such as pressure, temperature, etc.
Follow job SOPs; complete and record production record. Wear protective clothing on arms, hands, and elsewhere as required.
Keep machine and work area clean.
Report unusual conditions to supervisor.
Observe company safety rules and regulations.
Perform, as assigned, other similar or related duties, i.e. Metalizer.
Handle hazard waste from work area to accumulation site.
Frequently lift and/or carry up to 40 pounds.
Education: High School diploma or equivalent
Skills: Read and understand prints, work instructions, and other production documents. Basic math
skills (addition, subtraction, multiplication, division).
Experience: 1 years’ experience in a manufacturing environment
Competencies: Dependable, energetic, positive attitude, detail-oriented